Türkçe 
Description
It is a two-component, fully elastic insulation material that provides water and moisture insulation, which is mixed into cement-based concrete and plasters during the preparation phase.
Features
- Resistant to chlorinated water contact.
- Resistant to chemicals and salt solutions in the soil.
- It is suitable for use in motion and vibration areas.
- Thanks to its high adhesion and elasticity, it creates a perfect waterproof layer under screed and ceramic.
- Thanks to its flexible structure, it has the feature of bridging shrinkage cracks.
- It has a crack covering power up to approximately 0.92 mm with 2 mm application.
- Its working time and life is long, it can be applied easily.
- It is suitable for use in drinking water tanks.
Usage Areas
It is used on surfaces exposed to water pressure such as pools and water tanks, in wet areas such as terraces, bathrooms, basements, and in damp places, and on concrete to be poured.
It is used for basic insulation, retaining walls, indoor and outdoor vertical and horizontal applications, in plasters to be made in the direction of the water flow.
It is used for basic insulation, retaining walls, indoor and outdoor surface and horizontal applications, in plasters to be made in the direction of water flow.
It is used in facilities that are constantly exposed to water, such as spas, baths, pools, and concrete.
C20 and above can be used to increase the quality of concrete.
Application and Consumption
The application surface should be clean, sound, free of all kinds of oil, rust, cement residues and dirt that prevent adhesion. Before starting the application, large pores and cracks should be filled with repair mortar. The surface should be moistened and kept moist during application. After the first layer of Izowhite® Powercon® is applied, areas suitable for cracking such as sharp ends, horizontal and vertical joints should be rounded off with repair mortar or chamfer tape and a second layer of Izowhite® Powercon® should be applied on this chamfer.
Izowhite® Powercon® liquid B component is placed in a clean container and powder A component is slowly added under a low speed mixer and mixed until a homogeneous and lump-free mixture is obtained (approximately 3-5 minutes). The prepared mixture should be applied with a brush in two or three layers, with the application direction of each layer perpendicular to each other. Each coat should be applied while the previous coat is starting to harden. If necessary, the surface should be slightly moistened before applying the second coat. The prepared mixture should be consumed within a maximum of 2 hours. In external surface applications, the surface should be protected from sun, wind, frost and rain for the first 24 hours.
Packaging and Storage
It is used by adding 5 liters to the mortar for 1 (m³) before pouring in C20 and higher dose concretes. A mixture of 1.0 – 1.5 kg/m² is used for each layer. It is recommended to apply at least 2 coats and 3 coats if necessary. Never dilute it with water or any other liquid. Store away from direct sunlight. 20 kg and 5 kg drums.
